Home
Design
Pools & Spas
Outdoor Kitchens
Hardscape
Ponds & Fountains
Woodwork
Lighting
Fireplaces
The Oaks
Family Fun
Libation Sensations
Bookstore
HGTV
In The News
Project Profiles
Testimonials
Behind The Scene
Plants
Customer Tools
Financing
Vendors
Gardener's Checklist
Site Map
Contact Us

The Green Scene in Watershapes, October 2010

Singing the Relief-Valve Blues
By Scott Cohen

Let’s start this time with a key definition.

In the deepest part of a typical pool, you ordinarily carve out a two-by-two-foot box and backfill it with gravel. On top of that gravel sits a valve designed to open when the water pressure outside the shell is greater than the pressure inside the shell — thereby allowing water that builds up around the shell to flow into the bottom of the pool. That device is known as a hydrostatic relief valve.

Hydrostatic relief valves are used to help prevent the possibility that when a pool is emptied for maintenance or service, pressure on the shell might build to such a point that even a concrete shell can pop up out of the ground.

hydrostatic relief

There is no more spectacular pool failure (except for having one roll down a steep slope), and it leaves the homeowners with a repair bill so monumental that they’ll do everything in their power to extract the cost from the builder.

In most cases, hydrostatic relief valves are installed when pools are located at the base of a slope where groundwater tends to collect or build up, or in areas known to have naturally high water tables. It’s an unpredictable risk in many cases, so lots of the engineers and geologists I know specify the valves for all pools as a simple precaution — better safe than sorry.

Scenario: I was called in as an expert witness to examine a project where saturated soil had caused decks around the pool to heave. The pool itself had not popped, but it was leaking so badly that the autofill system ran constantly and the soil around the pool was obviously saturated to the point where the decks were in jeopardy. Not only was it a leak, it was a big leak.

We found that the pool had been prepared for the installation of a hydrostatic relief valve, with the two-foot cube set beneath the sump of the main drain and the requisite two-and-a-half-inch pipe sticking up into the sump where the valve should have been but wasn’t.

It’s common in these projects to have the plasterer install the valve, which is just a small plastic device that easily attaches to the top of the standpipe. Sometimes, however, plasterers forget to take this step and then mask it by prematurely covering the main drain with its grate. It’s a careless mistake, and it’s exactly what happened in this case.

hydrostatic

To read the entire article, buy THE CANDID CONTRACTOR: Lessons Learned From The Construction Defect Expert Witness Files of Scott Cohen

Contractors and homeowners will save thousands of dollars with this new book from Scott Cohen of HGTV fame. Cohen pulls back the veil on common construction mistakes with pools, ponds, decks and associated structures, explaining how to remedy them when they occur – or, better yet, avoid them entirely.


Scott Cohen is president and supervising designer of The Green Scene, an outdoor design and construction firm based in Northridge, CA. He provides consultation for clients nationwide and gives seminars on designing landscapes, swimming pools and outdoor kitchens.